Polydimethyldiallylammonium chloride – “precise dosage” in municipal sewage

In the flotation tanks and deep treatment sections of municipal sewage treatment plants, polydimethyldiallyl ammonium chloride is a cationic polymer agent with a strong presence. It does not need to be added in large quantities at tens or hundreds of mg per liter like inorganic coagulants. However, it can quickly capture small colloids, humus and colored particles in the water by virtue of its high charge density, helping the subsequent process to significantly reduce the turbidity and color of the effluent. However, when many novice operators first come into contact with it, it is easy to fall into two extremes: either the dosage is too small and no obvious flocculation effect is seen, or too much is added at once. Not only does the water quality not improve, but the viscosity of the water body increases, the scum in the subsequent sedimentation tank increases, and the total nitrogen index of the effluent also fluctuates abnormally. In fact, its reasonable dosage in municipal sewage is never a fixed number, but a precise range that changes dynamically with the water inlet working conditions, treatment stages and subsequent process requirements.

Under normal treatment conditions of conventional municipal sewage, the dosage of Polyquaternium-6 polydadmac is actually far lower than many people expect. After the front-end coarse screen, fine screen and primary sedimentation tank treatment, most of the large suspended solids in the municipal sewage have been removed, and most of what remains are stable colloids and soluble anionic organic matter with particle sizes in the micron range. In this case, when added to the coagulation unit for advanced treatment, only a few milligrams of chemicals per liter of water are needed to achieve obvious effects. Many water plants will use it in combination with polyaluminum chloride. They first rely on inorganic coagulants to destabilize most of the colloids, and then add a small amount of polydimethyldiallylammonium chloride, using its long molecular chains to complete adsorption and bridging. The finely divided alum flowers are quickly gathered into groups to form dense large flocs that settle quickly. In this combination mode, the dosage of pharmaceuticals can even be reduced to a lower level, and there will be no problem of excessive pharmaceutical residues.

The fluctuation in the dosage of Water soluble cationic polymer pdadmac first follows the fluctuation of municipal sewage water quality. During the rainy season, a large amount of rainwater enters the sewage treatment plant through the overflow of the pipe network. The turbidity of the incoming water will suddenly increase, and the proportion of sediment-like inorganic colloids in the water will increase significantly. At this time, it is necessary to increase the dosage of chemicals appropriately to ensure sufficient positive charges to neutralize a large number of newly added negatively charged colloids, and to avoid the problem of small flocs and slow settling speed. In the dry season, the proportion of domestic sewage in the incoming water becomes higher, and the proportion of organic impurities such as humus and oil increases. At this time, the dosage of chemicals cannot be increased blindly, but fine-tuning must be carried out through small trials to avoid excessive cationic chemicals and anionic organic matter in the water from forming stable complexes that are difficult to settle, causing the COD of the effluent to rebound. Even on the same day, the quality of the incoming water will change slightly at different times in the morning, middle and evening. The experienced operation team will conduct a small beaker test every two hours to adjust the dosage to the optimal value suitable for the current water quality at any time.

Different treatment process sections have very different dosage requirements for Cationic polyelectrolyte poly dadmac. If it is used in the air flotation process section, the purpose is to quickly attach the light floc and algae in the water to the bubbles to float, and the dosage of the agent must be controlled in a lower range.

P2_Liquid_vs_Powder P4_6_Application_Fields P6_Packaging_Delivery

Post time: Nov-18-2026